Siemens FDV241 Manual De Inicio página 58

Setup
22
Building Technologies
Fire Safety & Security Products
Inserting the compact flash card
Select a recommended compact flash.
1.
Open the device. See Section 9.1: Opening/closing the device.
2.
Press and hold the ON/OFF switch (1) for approx. 2 seconds.
3.
The device switches off, which can take several seconds.
Once the device is switched off, the Power LED (3) will no longer be lit.
Insert the compact flash card in the Compact Flash Slot (2).
4.
Press the ON/OFF switch (1).
5.
The device boots up.
The Power LED (3) lights up.
Close the device. See Section 9.1: Opening/closing the device.
6.
Activate the compact flash card. Further information on this can be found in
7.
the SISTORE SX/CX Configuration Manual.
Format the compact flash card. Further information on this can be found in the
8.
SISTORE SX/CX Configuration Manual.
Removing the compact flash card
Deactivate the compact flash card. Further information on this can be found in
1.
the SISTORE SX/CX Configuration Manual.
Open the device. See Section 9.1: Opening/closing the device.
2.
Press and hold the ON/OFF switch (1) for approx. 2 seconds.
3.
The device switches off, which can take several seconds.
Once the device is switched off, the Power LED (3) will no longer be lit.
Remove the compact flash card from the Compact Flash slot (2).
4.
Press the ON/OFF switch (1).
5.
The device boots up.
The Power LED (3) lights up.
Close the device. See Section 9.1: Opening/closing the device.
6.
11.2008