Controls & Operation; Important - MTD CSV 020 Manual Del Operador

Controls and Operation
Recoil Starter
Chipper Chute
Controls
WARNING:
The operation of any
chipper shredder can result in foreign
objects being thrown into the eyes,
which can damage your eyes severely.
Always wear the safety glasses provided
with this unit or eye shields while
operating or while performing any
adjustments or repairs.
Chipper Chute
Allows twigs and small branches up to 1-1/2" in
diameter to be fed into the impeller for chipping.
Nozzle Height Adjustment Lever
Used to adjust the nozzle ground clearance ranging
approximately 5/8" to 4 1/8".
Nozzle
Yard waste such as leaves or pine needles can be
vacuumed up through the nozzle for shredding.
Bag
Collects shredded material fed through the chipper
chute or vacuumed through the nozzle.
Recoil Starter
The recoil starter is attached to the right upper
handle. Stand behind unit and pull the recoil starter
to start engine.
Engine Controls
See the separate engine manual for the location and
function of the controls on the engine.
6
Bag
Nozzle Height
Adjustment Lever
Figure 4-1
Operation
Starting & Stopping Engine
Refer to the Engine Operator's manual packed with
your chipper/shredder vacuum for instructions on
starting and stopping the engine.
To Empty Bag
1. Unhook bag straps from the lower handle.
2. Unsnap bag clip from the top of lower handle.
See Figure 4-2.
4
1
3. Grasp bag handle with one hand and pull lock
rod on mounting bracket with other hand
toward engine to release.
4. Lift bag off back of unit.
Nozzle
2
3
Figure 4-2
5. Twist the two buttons on the back of the bag
to unlock and empty contents. See Figure 4-3.
Hold bag handle and bag clip while emptying
the contents.
Outer Flap
Figure 4-3
6. Compress bag opening and fold inner flap
over opening.
7. Fold outer flap over inner flap and insert
buttons on the bag through metal outlets. See
Figure 4-3.
8. Twist the buttons to lock bag. Place bag back
onto unit as instructed in Assembly & Set-Up.
WARNING:
Do not at any time make
any adjustments without first stopping
engine and disconnecting spark plug
wire.
WARNING:
Do not attempt to shred,
chip, or vacuum any material larger than
specified on the machine or in this
manual. Personal injury or damage to the
machine could result.
IMPORTANT: The flail screen is located inside
the housing in the discharge area. If the flail
screen becomes clogged, remove and clean as
instructed in the Service section of this manual.
For best performance, it is also important to
keep the chipper blade sharp.
4
Buttons
Inner
Flap