Controls & Features - MTD 450 Serie Manual Del Operador

Controls and Features
Chipper Chute
Chipper Chute
Model Series 450: Allows twigs and small branches up to 2" in
diameter to be fed into the impeller for chipping.
Model Series 460: Allows twigs and small branches up to 3" in
diameter to be fed into the impeller for chipping.
Hopper
Allow leaves and small branches up to 1/2 diameter to be fed into
the impeller for chipping and shredding. Material can be raked
into the hopper by lowering it down to the ground.
Release Rod
The release rod is located on the impeller bracket assembly and it
is used to release or lock the hopper when raising or lowering.
10
Hopper
Release Rod
Figure 4-1
Discharge Chute
Debris exists the machine's reduction chamber through the
discharge chute.
Recoil Starter
The recoil starter is located on the engine. Pull recoil starter to
start the engine.
Engine Controls
See the engine operator's manual packed with your unit for the
location and function of the controls on the engine.
Discharge Chute
Model Series 460 Shown
4