Connecting A Touch Probe; Connecting The Line Voltage - ACU-RITE DRO 100 Serie Instrucciones De Instalación

5.6

Connecting a touch probe

The following touch probe can be connected
to a DRO 30x product:
HEIDENHAIN KT 130 edge finder
Further information:
Remove and save the dust protection caps
Route the cables depending on the mounting variant
Further information: "Assembly", Page 10
Connect the touch probe tightly to connection X10
Further information: "Product overview", Page 12
If the cable connectors include mounting screws, do
not overtighten them
Pin layout of X10
Further information: "Q", Page 38
ACU-RITE | DRO 100, DRO 203, DRO 300 | Installation Instructions | 01/2018
"Accessories", Page 9
5.7

Connecting the line voltage

WARNING
Risk of electric shock!
Improper grounding of electrical devices may result in
serious personal injury or death by electric shock.
Always use 3-wire power cables
Make sure the ground wire is correctly connected to
the ground of the building's electrical installations
WARNING
Fire hazard from the use of power cables that
do not meet the national requirements of the
respective country in which the product is
mounted.
Improper grounding of electrical devices may result in
serious personal injury or death by electric shock.
Use only a power cable that meets at least the
national requirements of the respective country in
which the product is mounted
Use a power cable that meets the requirements to
connect the power connection to a 3-wire grounded
power outlet
Further information: "Product overview", Page 12
Pin layout of the power connection
Further information: "R", Page 38
13