Tru-Test S150 MkII Manual De Uso página 9

Protection from the weather shall be provided
for the ancillary equipment unless this
equipment is certified by the manufacturer as
Servicing
This energizer contains no user serviceable parts. It must be returned to a service agent appointed by Tru-
Test Group for repair.
Troubleshooting
Problem
The Pulse indicator
light is flashing, but the
electric shock delivered
by the fence is weak.
The Pulse indicator
light is not flashing.
Action
Check that all connections in the fence and earth system are firm and secure. If
necessary, clean away any corrosion.
Check that the earth rod is pushed firmly into firm ground.
Check for faults in the fence-line caused by trees or vegetation. If necessary, remove
obstructions and mend the fence.
Check that the energizer is adequate for the length of the fence. If necessary,
reduce the length of the fence or reduce the number of fence wires. Alternatively,
divide the fence-line into smaller zones, with each zone powered by a separate
energizer.
Check that the energizer is switched on.
If there has been insufficient sunlight to charge the battery, the energizer may be in
Battery protection mode. Charge the battery by placing the energizer in full sunlight
with the solar panel facing true north in the southern hemisphere and true south in
the northern hemisphere and .
Ensure the battery is connected correctly with the positive (red) lead to the positive
(+) terminal on the battery and the negative (black) lead to the negative (–)
terminal on the battery.
Try charging the battery manually using a suitable battery charger. See
charging
on page 5.
Replace the battery with a new battery. Before installing a new battery, charge it
fully using a suitable battery charger.
If the pulse indicator light is still not flashing, return the energizer to a service agent
appointed by Tru-Test Group for repair.
being suitable for use outdoors, and is of a type
with a minimum degree of protection IPX4.
Battery
9