Nikko N-BLASTER Manual De Usuario página 22

Please check the headings I - VI with the
diagrams in pages 2, 3, 4, 5.
I - CONTENTS & FEATURES
A
N-Blaster
B
Transmitter
C
6.0V NiMH battery pack
D
9V (6LR61) battery
E
NiMH Battery charger
F
6 Missiles
N-BLASTER
1
A
Body
B
Front Wheel
C
Rear Wheel
D
On/Off Switch (bottom of the vehicle)
E
LED Target Light
2 TRANSMITTER
A
Transmitter Antenna
B
Control Stick for Left Side Wheel
C
Control Stick for Right Side Wheel
D
Shooting Button
There is no on/off switch on the Transmit-
ter. Moving the sticks turns it on automati-
cally.
II - BATTERY INSTALLATION
TRANSMITTER
1
A
Slide open the battery lid in the direction
as shown in the figure, while lightly pres-
sing its center.
B
Insert a 9V (6LR61) battery with the pola-
rity (+/-) as shown on the bottom of battery
compartment.
C
Place the battery lid, following the removal
procedure in reverse.
To remove the batteries, reverse the
installation procedure.
2 N-BLASTER
This product should be used with adult
supervision.
Charge the 6.0V NiMH battery pack fully in
advance of your use
A
Turn the latches located underneath of ve
hicle to unlock, remove body as shown in
the figure with arrows.
B
Turn the latches on vehicle battery lid to
unlock and open.
C
Insert 6.0V battery pack into battery com
partment with correct polarity (+/-).
D
Close battery lid, turn the latches to lock.
E
Follow the arrow.
F
Replace body following the removal
procedure in reverse, turn the latches
underneath of vehicle to lock.
N-BLASTER
III - BEFORE OPERATION
Turn vehicle power ON.
On/Off Switch is on the bottom of the
vehicle.
IV - THROTTLE CONTROLS
A
FORWARD (Push both sticks forward)
B
BACKWARDS (Pull both sticks back-
wards)
C
LEFT TURN (FORWARD) (Push right stick
forward)
RIGHT TURN (BACKWARDS)
(Pull right stick backwards)
D
RIGHT TURN (FORWARD) (Push left
stick forward)
LEFT TURN (BACKWARDS)
(Pull left stick backwards)
E
LEFT SPIN
(At the same time, pull left stick back and
push right stick forward)
F
RIGHT SPIN (At the same time, pull right
stick back and push left stick forward)
G
SHOOTING (Aim at your target using the
target light. Press the button to launch a
missile)
V - CAUTION DURING
PLAYING WITH VEHCLE
A
Do not drive your vehicle on streets or in a
crowded place.
B
Do not store the vehicle in a place near a
heater or where temperature rises.
After use, remove the batteries from trans-
mitter and vehicle to store.
C
Adult supervision is strongly recommen-
ded.
D
DO NOT drive the vehicle in water.
If the vehicle and/or transmitter get wet,
discontinue to use until they are comple-
tely dry.
E
Thoroughly wipe off all moisture and allow
them to air-dry completely before use.
VI - CAUTION WHEN
INSERTING MISSILE
Pay attention to the three notches on the
missile. They need to be aligned properly
to the notches in the Missile Launcher.
VIII - SAFETY CIRCUIT
During use, the internal power in the electric
circuit can get quite high (for example during a
360 spin).
In such a case a safety circuit will shut down
the vehicle for approximately 10-15 seconds.
During this period the car will not respond to
signals from the transmitter. This is not a defect
but a safety measure to protect the electronic
circuits. After this period, the car will resume
normal operation.
TROUBLESHOOTING GUIDE
Make sure the vehicle power is on.
Make sure the batteries in transmitter and
vehicle have sufficient charge.
Check if the batteries in transmitter and
vehicle are inserted with correct polarity.
22
Check if the distance between transmit-
ter and vehicle will not exceed more than
20m.
Two or more vehicles of the same fre-
quency will interference with each other. In
such a case, move to another place or try
after a while.
Veuillez contrôler les rubriques I - VI ci-
desous, avec les schémas des pages 2, 3,
4, 5.
I - CONTENU ET
CARACTERISTIQUES
A
N-Blaster
B
Emetteur
C
Batterie 6,0V NiMH
D
Pile 9V (6LR61)
E
Chargeur NiMH
F
3 missiles de rechange
1 N-BLASTER
A
Carrosserie
B
Roue avant
C
Roue arrière
D
Interrupteur On/Off (soubassement du
vehicule)
E
Cible Lumière LED
EMETTEUR
2
A
Antenne de l'émetteur
B
Commande des roues gauches
C
Commande des roues droites
D
Bouton de tir
Il n'y a pas d'interrupteur on/off sur
l'émetteur. La mise en mouvement des
commandes l'active automatiquement.
II - MISE EN PLACE DE LA
PILE ET DE LA BATTERIE
EMETTEUR
1
A
Faites coulisser le couvercle de la pile
dans le sens indiqué sur le schéma, tout
en appuyant au centre.
B
Insérez une pile 9V (6LR61) en plaçant la
polarité (+/-) comme indiqué dans la partie
inférieure du compartiment de la pile.
C
Replacez le couvercle de la pile, suivant la
procédure d'extraction en sens inverse.
Pour ôter la pile, utilisez la procédure
d'installation dans l'ordre inverse.
2 N-BLASTER
Cet appareil doit être utilisé sous la super-
vision d'un adulte.
Chargez complètement la batterie 6,0V
avant utilisation.
A
Tournez les loquets situés sous le véhi-
cule pour déverrouiller la carrosserie et
ôtez-la comme indiqué dans le schéma