CHIEF CM2C40 Instrucciones De Instalación página 13

Installation Instructions
NOTE:
Holes are provided in the faceplate for use with a
padlock or similar locking device, if desired. In addition,
the pin and nut may be removed from the upper holes
and moved to the lower holes for use as a more
permanent locking device. (See figure 19)
Remove pin
1
and nuts and
move to lower holes.
A padlock or bolt may
be placed through latch
holes
Figure 19
4. Loosen four nuts securing right and left hand bottom cover
adjustment brackets to faceplate mounting bracket.
(See figure 20)
5. Slide bottom cover adjustment brackets upward or
downward until lip on bracket is positioned 1/4" below the
bottom of display. (See figure 21)
6. Tighten four nuts to secure bracket in position.
(See figure 20)
Bottom Cover
Mounting Bracket
WARNING:
SEVERE PERSONAL INJURY OR DAMAGE TO
EQUIPMENT! Make sure all four nuts are tight before
continuing installation!
Display removed
for clarity
2
4
1/4" minimum
Figure 21
IMPROPER INSTALLATION CAN LEAD TO
X4
Figure 20
Display
CM2C40
5
3
Bottom Cover
Mounting Bracket
13