CHIEF CM2C40 Instrucciones De Instalación página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Instructions
10
6
Figure 3
7.
Remove two locknuts securing faceplate to faceplate
mounting bracket. (See figure 4)
8.
Move faceplate up one set of holes to adjust location 1" or
two sets of holes to adjust 2". (See figure 4)
8
Figure 4
9.
Secure faceplate to faceplate mounting bracket using two
locknuts. (See figure 6)
6
10
5
4
1"
(25MM)
8
7
x2
10. Using the remote control, lower the lift until it stops.
(See figure 3)
If more than 2" of faceplate adjustment is required:
11. Raise lift following instructions in step 6. (See figure 3)
12. Loosen four nuts securing faceplate mounting bracket to
frame. (See figure 6)
13. Move faceplate mounting bracket desired amount.
(See figure 6)
NOTE:
The CM2C40 is shipped with the faceplate mounting
bracket installed in the lower slots. An additional 2" of
faceplate adjustment can be obtained by moving the
faceplate mounting bracket to the upper slots slots.
14. Tighten four nuts to secure faceplate mounting bracket to
frame.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
SEVERE PERSONAL INJURY OR DAMAGE TO
EQUIPMENT! Make sure all four nuts are tight before
continuing installation!
12
X4
14
X4
CM2C40
x2
9
Figure 5
13
Figure 6
7

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido