Steam Nozzle; Drip Basin; Emptying Used Coffee Grounds; Water Tank - Fulgor Milano FCM 4509 TC Manual De Instrucciones

Steam nozzle

In addition, periodically clean the steam nozzle, which
can get dirty inside when you warm milk for cappuccino.
To do this, just disassemble it as shown in the figure
and wash it together with its hood with a sponge and
hot water.
ATTENTION: when cleaning the nozzle,
always turn off the machine and remember to
wait at least 20 minutes before using it to allow
it to cool, avoiding possible burns.

Drip basin

Remove the drip basin from the machine as shown in the
following figures.
Make sure to periodically empty the basin to avoid
liquid spills that could dirty and ruin the furniture below.
The basin and relative metal grill can be washed in the
dishwasher.

Emptying used coffee grounds

To open the door of the compartment with the tray, you
must first remove the drip basin as described in Figures
16.4 and 16.5.

Water tank

• If the machine has not been used in a long time, we
recommend changing the water in the tank
• Periodically clean the water tank of any lime
encrustations.
• The tank can be washed in the dishwasher.
• If using the Brita decalcifying filter, we recommend
replacing the filter every 2000 espresso coffees or at
least every six months.

17. TROUBLESHOOTING

The operator should make sure that the problem is not
caused by:
- No electricity
- No water in the tank
- No coffee in the machine
- Incorrect closure of the access door to the coffee
ground tray.
For any other causes, have the machine checked by a
service centre.
31
Remove the tray, empty the
coffee grounds and wash
it with hot water or in the
dishwasher.
Put the "used" coffee
ground tray back in its
compartment.
GB