First Use; Fill The Water Tank - Fulgor Milano FCM 4509 TC Manual De Instrucciones

The exclusive feature of this model is the use
of touch-control technology. Just touch the area
of the symbol and the machine will perform the
corresponding function. However, you will notice that
you must exert slight pressure to activate the controls,
just like a normal button; this is to avoid accidental
GB
commands.

7. FIRST USE

Fill the water tank

Fig. 7.1 Remove the drip basin from its seat
Fig. 7.2 Press the unlocking lever under the drip basin
and pull the machine towards you as shown in the figure.
Fig. 7.3 Pull the coffeemaker out of the furniture by
sliding it on its guides.
Insert the decalcifying filter in its seat.
Fig.7.4
Before filling the water tank, make sure that the
decalcifying filter was soaked in cold water for at least
20 minutes (in any case, follow the instructions on the
filter package). After soaking, insert it in its seat inside
the tank, as shown in the figure, until you hear a click.
If the machine has not been used in a long time, we
recommend changing the water in the tank.
The filter can be purchased at an appliance store, our
Service Centres or at authorised replacement parts
stores.
Fig. 7.5 Remove the water tank as shown in the figure
and fill it with drinking water (about 2.5 litres).
Fig. 7.6 Put the tank back in its seat, taking care to
match up the two connections on the bottom.
24