Video Recording - Aukey DRA2 Manual De Instrucciones

Audio Recording: Mute/unmute the microphone. When audio
recording is on, in-car audio will be recorded during video recording
Screen Brightness Adjustment: Choose from 5 screen brightness levels
Playback: Preview, lock/unlock, or delete recorded videos
Recording: Start/stop recording. There will be a short delay to begin
and end writing videos to storage
Screen View Switch: Switch between 3 screen view options– dual
view, front camera, and rear camera (in that order). Touch the icon
or swipe horizontally across the screen
Video Protection: Lock/unlock a video in video recording mode.
Protected videos won't be overwritten by loop recording and
can only be deleted if you unlock them first
Settings: Change video and general settings. Touch the up & down
arrows to see more settings and settings options

Video Recording

● Loop Recording: Recording will begin automatically after powering
on with a microSD card in the device. Each recorded file is up to 3
minutes long, with old footage being replaced when microSD card
storage is full. The videos will be saved in the 'Normal' folder (or
'Emergency' folder if Emergency Recording is activated)
● Motion Detection Recording: Switch on motion detection in
'General Settings.' This function will start recording video when the
dash camera optically detects motion in front and stop recording
when motion is no longer detected. The videos will be saved in the
'Motion Detection' folder
Parking Mode: Switch on parking mode in 'General Settings.' The
●
dash camera will use its internal rechargeable battery to operate
even when the car ignition is turned off and power is disconnected. If
any motion or vibration is physically detected by the G-sensor when
parked, it will record automatically (screen off) for 10 seconds and
then turn off. The videos will be saved in the 'Emergency' folder
- 08 -