Video Recording - Aukey DR02 J Manual Del Usuario

Video Recording

● Loop Recording: Recording will begin automatically after powering on with a micro
SD card in the device. Each recorded file is up to ten minutes long, with old footage
being replaced when micro SD card storage is full.
● Motion Detection Recording: Switch on motion detection in 'Setup.' This function will
start recording video when the dash camera detects motion in front and stop recording
when motion is no longer detected.
● Time-Lapse Recording: Switch on time-lapse recording in 'Setup.' This function will
capture a picture per second to make a video played at the same number of frames
per second as the current recording resolution setting.
Emergency Recording
● Manual File Backup
Press to back up the current file so that it will not be overwritten. A
appear in the top left of the LCD screen to indicate a protected emergency recording
is in progress.
● Auto File Backup
Once the G-sensor is activated by a sudden impact, the device will automatically
make a recording and protect it from being overwritten. Adjust G-sensor sensitivity in
the 'Setup' menu.
Snapshot
● Hold down
● The snapshot files are located in the \ AUKEY\PHOTO folder on the micro SD card
● The icon will be shown after you take a snapshot. This will not interrupt the video
recording
Audio Recording
Turn on/off audio recording by long-pressing
adjusting in 'Setup' menu). When audio recording is on, in-car audio will be recorded
during video recording. Voicing details of possible hazards that may develop,
especially when off-camera, may provide useful information. You can even use it to
record car license plate numbers that may not be captured on the video.
for 3 seconds to take a snapshot while in recording mode
- 06 -
when in recording mode (or by
icon will