Installation Of Accessories - Paoli DP 6000 BIAS Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

REGULATION OF THE AIR PRESSURE
L Before the use, always perform a dynamic
adjustment of the supply air pressure
figure
Fig.5). Adjust the supply air pressure
on the low pressure gauge turning the
adjusting screw of the air pressure regulator
while keeping the trigger pressed.
HANDLING
L Please pay attention to the position of the
lever for change of directionality
Fig.1-L and
Fig.2-H) of your wheel gun.
L Slide the rotation reverse shaft
Fig.1-I), rotate the lever for change of
directionality
(view figures Fig.1-L e
and push the trigger
See the figure
Fig.4
direction of the square drive.

INSTALLATION OF ACCESSORIES

Before changing an accessory, always make
sure that the air supply line is depressurized (no
air pressure), and only after disconnecting the
wheel gun and replace it. Use only accessories
suitable for the job (view our catalogue for
accessories).
Use only impact sockets with a hole for the
locking pin.
Do not use chrome sockets or for manual use.
Do not use square drive adapters (reductions
or multiplies).
Always check that the locking pin of the socket
is present and secured firmly. To install the
wheel nut socket, proceed as follows:
L Mark each clutch cover with the wheel gun's
serial number.
ENGLISH
6
OPERATING AND MAINTENANCE MANUAL
(view
(view figures
(view figure
Fig.2-H)
(view figure
Fig.1-C).
to identify the rotation
L Do not exceed the maximum supply
air pressure of 25 bar (with wheel gun
running).
L Avoid accidental starting, being careful not
to unwittingly act on the trigger
Fig.1-C).
L See the figure
Fig.6
sequence of operation.
L Remove the four clutch cover (hammer
case) screws, discard lock washers.
L Holding the 1" square drive, remove the
anvil shank, clutch cover bearing and clutch
cover from gun. Clutch spring should
remain with clutch shaft, clutch plate and
clutch housing. Retain the anvil shank,
clutch cover bearing and clutch cover as an
assembled unit.
L Using an appropriately sized aluminum
block, support the 1" square drive from
the bottom. This will provide the base
for pressing the socket onto the square
drive. Make sure the block is tall enough
to allow clearance for the clutch cover.
(view figure
for a hypothetical

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Blue devil 3/4Dp 6000

Tabla de contenido