Ibx HM01 Manual De Usuario página 8

6.2 Heating Mantle with stirring, HM02 series
Put the heating mantle on top of a horizontal, flat, and stable table leaving at least 30 free cm
•
on each side. Do not place it near any heat source.
Connect the equipment to a power source.
•
Turn the Heat Knob (1) clockwise until you hear a "click"; this shows the heating mantle is ON.
•
The corresponding indicator will light up (2). To adjust the temperature, keep turning the knob
clockwise towards the desired temperature.
Turn the Stirring Knob (4) clockwise until you hear a "click"; this shows the heating mantle is
•
ON. The corresponding indicator light will light up (3). To adjust the stirring speed, keep
turning the knob clockwise until you reach the desired speed.
Placing the thermometer: Assemble the two parts of the rod and insert the rod in its support at
•
the back side of the equipment. Once the rod is placed, put the bosshead at the desired height,
hold it with the screw and put the thermometer clamp.
Note:
• The power used must match the machine's
requirements.
• Make sure the power line is at a safety
distance from the heating mantel.
• In case of any fault, cut off the electricity first.
Note:
• The power used must match the machine's
requirements.
• Adjust the power gradually and slowly.
• Make sure the power line is at a safety
distance from the heating mantel.
• In case of any fault, cut off the electricity
first.
8