Bissell ERASER 22814 Serie Guia De Inicio Rapido página 12

Clean Inner Cyclone Separator
1
Hold the Dirt Tank over
a trash container. Press
the bottom release
button to empty.
Maintain Pet TurboEraser® Tool
1
3
To reassemble, align two clips on each end
of Paddle Wheel with Belt on and pop back
into place. Place Brush Roll with Belt back
in. Faceplate will not close properly if all
parts are not aligned correctly.
12
www.BISSELL.com
2
Twist Cyclone counter-
clockwise and pull down
to remove from tank.
Twist gray collar
counter-clockwise, until
slot appears, and then
separate faceplate.
3
Tap separator against inside
of trash container and
rinse under warm water, if
necessary. Be sure to let
it dry completely before
placing back in Dirt Tank.
Paddle Wheel
2
Belt
Roller
Remove Brush Roll, Belt, and Paddle
Wheel. Inspect for damages and
replace if necessary.
4
To put faceplate back on, align the tabs
in the top of the cover and place it down
to "click" into place.