FIBARO CO SENSOR Manual De Instrucciones página 7

Description
FIBARO CO Sensor is a HomeKit-enabled carbon monoxide detector using Bluetooth® low energy
wireless technology. Its high sensitivity allows to detect the presence of the carbon monoxide (CO)
gas at the early stage in order to prevent carbon monoxide poisoning. Alarm is signalled with a
built-in siren, blinking LED indicator and by sending information to your iOS device. Additionally,
the accessory is equipped with a temperature sensor.
General carbon monoxide information
Carbon monoxide (CO) is a colourless, odourless, and tasteless poison gas that can be fatal when
inhaled. It is produced when liquid, solid, or gas fuel is burned.
Symptoms of carbon monoxide poisoning
The early symptoms of carbon monoxide poisoning can be confused with flu-like symptoms:
headache, dizziness and nausea. Breathing carbon monoxide causes these symptoms even in
healthy people. It can also cause sleepiness, vision problems (including blurred vision), ringing
in the ears, aching arms and legs, irregular breathing, fatigue and confusion. At very high levels, it
causes loss of consciousness and death.
Some external factors, eg. exposure to high concentration of basic (non-acidic) gases, silicone va-
pors, hydrogen sulfide or sulfuric acid gas, organic vapors, contact with water, dust and oil mist, or
dew condensation may affect the reliability of the device operation.
This device may not protect from long-term exposure to low levels of carbon monoxide which can
also lead to neurological symptoms.
WHAT YOU HEAR WHAT YOU SEE
4 x BEEP 4 x RED BLINK
every 5s
1 x BEEP 1 x YELLOW BLINK
1 x BEEP
every 30s
2 x BEEP 2 x CYAN BLINK
1 x BEEP 1 x WHITE BLINK
— 1 x GREEN BLINK after
1 x BEEP 1 x GREEN BLINK
after powering
1 x BEEP 1 x RED BLINK
after powering
— CYAN BLINKING
DETECTED PRESENCE
every 5s OF CARBON MONOXIDE
WHICH CAN KILL YOU!
every 30s
—
CARBON MONOXIDE
every 30s
button press
WHAT IT MEANS
Low battery level
Sensor error,
DOES NOT DETECT
End of lifespan
Tamper alarm
Accessory
powered
Paired with
HomeKit
Not paired with
HomeKit
Firmware update
WHAT TO DO
1. Open windows
2. MOVE TO FRESH AIR!
3. Contact emergency services
Replace battery
Reset accessory,
replace if no effect
Reset accessory,
replace if no effect
Check housing
—
—
—
Wait for completion
7