Grundig MC 6840 Manual Del Usario página 22

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 40
POWER SUPPLY __________________________
Operating with the power
adapter
Check that the voltage indicated
on the rating plate of the power
adapter corresponds to your local
power supply.
The only way to disconnect the ap-
pliance from the power supply is to
unplug the power adapter.
1
Plug the charging plug into the
appliance socket and the power
adapter into the wall socket.
Note
The groove on the charging plug
7
must match the notch in the appli-
ance socket.
– LED ring
ing, when the batteries are
changed. Once the clipper is
completely charged, LED ring
D
will illuminate continually.
D
2
LED ring
when the unit reaches low battery
capacity during operation.
– When the batteries are dis-
charged: LED ring
display.
22
ENGLISH
D
will start flash-
will start flashing
D
will not
Notes
Discharge the appliance through
7
normal use. Then recharge to
full capacity. Maximum battery
capacity will only be reached
after several charging/discharg-
ing cycles.
When charging the unit, it can be
7
used to cut the hair, LED ring
will illuminate continually.
The adapter and unit
7
come warm while charging; this
is normal operation.
Caution
Please do not operate the unit
7
connected to the power adapter
for a long time or it may burn out
the adapter.
3
Unplug the adapter from the wall
and the base when not in use.
Caution
When in the bathroom or beside
7
a water connection, only use the
appliance in battery mode; never
run it from the mains.
D
F
may be-

Publicidad

Tabla de contenido
loading

Tabla de contenido