Paper Handling; Changing The Paper Type - MPI Tally Dascom T2265+ Guia De Instalacion

Quick start guide

Paper handling

This section describes how to set the paper type, load fanfold paper and single sheets, transport
paper and move the paper to the tear position.
➤
You can change the paper type either from an application program, by means of the paper path
Changing the paper
quick selection feature or in the Setup menu. In this section, the quick selection feature is
type
described; for detailed information on how to make this setting via the Setup menu, refer to the
User Guide on the Online CD-ROM.
On some printer models, the single sheet paper source cannot be selected since these models
are not designed for manual single sheet feeding.
Offline Trac1
Online
Park Load
1 2 3 4
Setup
Single Trac1
Online
1 2 3 4
Setup
Load paper from
Online
Single
1 2 3 4
Setup
Online Single
Online
Load
1 2 3 4
Setup
Mantenimiento Periféricos Informaticos C/Canteras, 15 28860 Paracauellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/
Make sure that the printer is in offline mode; press the Online key, if necessary.
Press the Park (1) key. If fanfold paper is loaded in the printer, it is fed to the tear
position. The text tear paper off appears in the display. Then press any key. If a
single sheet is loaded in the printer, it is ejected.
Use one of the marked keys to select the desired paper path, for example,
Single (2).
If you do not make a selection within 5 seconds, the menu is closed.
The printer returns to offline mode. The display alternates between the basic menu
and the menu in the following figure:
Insert a single sheet (for the procedure, see page 19, Loading single sheets).
Press the Online key to set the printer to ready status. When the printer receives
data from the computer, the single sheet is automatically loaded. Press the Load
(4) key to load the single sheet before starting the printout.
Paper handling
15