Connecting The Printer; Switching On The Printer - MPI Tally Dascom T2265+ Guia De Instalacion

Quick start guide
➤

Connecting the printer

➤

Switching on the printer

Mantenimiento Periféricos Informaticos C/Canteras, 15 28860 Paracauellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/
Make sure that the printer is set to the correct voltage (e.g. 230 V
in Europe, 120 V in the U.S.A.). To do this, check the plate
above the power inlet at the rear of the printer.
If the setting is incorrect, set the coloured switch at the rear of
the printer to the correct position, using a pointed object (e.g.
screwdriver, ball pen or tweezers).
Make sure that the printer is switched off before
STOP
setting the correct voltage; otherwise severe dama-
ge may be caused.
Never switch on the printer if the voltage setting is
incorrect, since this may cause severe damage to the
printer.
Make sure that the printer and the computer are switched off,
and connect the printer to the computer with the data cable
(interface cable).
The printer by default is provided with a parallel and
an Ethernet interface. For further information about
the interfaces, refer to the User Guide on the Online
CD-ROM.
Connect the power cable to the power inlet of the printer.
Connect the power cable plug to a mains socket.
The power switch for switching on the printer is located at the
bottom left at the front of the printer when viewed from the
front.
Installation
7