Power Line Frequency - Axis P33 Serie Guia De Instalacion

AXIS P33/P33-V Network Camera Series Installation Guide
6. AXIS P3346-V/AXIS P3367-V:
The capture mode must be set the first time network
camera is accessed. Select the desired capture mode
from the drop-down list and click OK.
Note:
The capture mode can be changed later from the prod-
uct's web pages, but this will reset most other settings.
For more information, see the online help or User's
Manual.

Power Line Frequency

Note:
Only applicable to AXIS P3384-V.
Power line frequency is set the first time the Axis product is accessed and can only be changed by
resetting the product to factory default.
Select the power line frequency (50 Hz or 60 Hz) used at the location of the Axis product. Selecting
the wrong frequency may cause image flicker if the product is used in fluorescent light
environments.
Note:
When using 50 Hz, the maximum frame rate is limited to 25 fps.
Note:
Power line frequency is different in different geographic regions. In the Americas, 60 Hz is usually
used; most other parts of the world use 50 Hz. Local variations may apply, always check with the
local authorities.
Page 13