Maintenance Instructions; Maintenance - General Rules; Replacing/Installing The Main Brush - Dulevo SPARK 1000 BH Uso Y Mantenimiento

Tabla de contenido

Idiomas disponibles

1000 BH - 1000 EH - 1000 YH

Never perform any maintenance operations without first disconnecting the batteries.

Maintenance of the electrical circuit and all other operations not expressly required by this

manual must be performed by specialised personnel only, in compliance with current safety

legislation and as described in the maintenance manual.

Maintenance - General rules

Performing regular maintenance according to the Manufacturer's instructions improves perfor-

mance and extends the working life of the machine.

When cleaning the machine, observe the following precautions.

►

Avoid using pressure washers. Water could penetrate the electrical compartment or mo-

tors leading to damage or short circuits.

►

Do not use steam to avoid the heat warping plastic parts.

►

Do not use solvents or hydrocarbon based products. These can damage the cowling and

rubber components.

Replacing/installing the main brush

This operation must be performed with the machine switched off and the key removed.

Proceed as follows to replace the main brush.

►

Unscrew the knob and open the door on the left of the machine.

►

Unscrew the three knobs securing the brush compartment cover (fig. 15).

►

Remove the brush compartment cover (fig. 16).

►

Pull out the brush (fig. 17).

►

Remove the adapter from the core of the old brush and fit it to the new brush, taking care

to keep the bristles aligned in the same direction (fig. 18).

►

Fit the adapter with the new brush in the machine, taking care to ensure that the adapter

engages the drive hub securely. Fit the cover over the brush compartment and fix it in place

with the three knobs removed previously.