Standard Setup/Cable Connections; Operating The Vortex; Selecting Channels; The Vortex™ And Signal Processors - Hughes & Kettner VORTEX Serie Manual De Instrucciones

VORTEX - MANUAL
REAR PANEL:
MAINS: Connect the included Euro-norm mains
cord to this socket. Ensure the amp's voltage
rating matches your local AC voltage rating
before you plug the cord into the wall socket.
SPEAKER OUTPUTS:
Serial on combos: Connect an auxiliary cabinet
with a minimum impedance of 2 ohms here.
Parallel on heads: Connect the included
4x12" cabinet and another auxiliary cabinet with
a rating of at least 8 ohms here. The minimum
permissible impedance is 4 ohms. This means if you
connect cabinets to both outs, each cabinet's
impedance may be no lower than 8 ohms.
Combo-versions

4.0 OPERATING THE VORTEX™

4.1 SELECTING CHANNELS

You can activate the channels of the VORTEX™
via the front panel CHANNEL SELECT button or an
external footswitch. The Hughes & Kettner
of accessories offers a footswitch that fits the bill,
the FS 1.
6
6
3.0 STANDARD SETUP /
HEAD/COMBO:
Head-version
4.2 THE VORTEX™
The VORTEX™ is equipped with a serial effects
® range
loop, meaning that the entire preamp signal is
routed to the FX device and processed there.
CABLE CONNECTIONS
AND SIGNAL PROCESSORS