Dmx Linking - Chauvet DJ MotionDrape LED Guía De Referencia Rápida

MotionDrape LED QRG
Product
Description
Product Overview
AC Power
Fuse
Replacement

DMX Linking

Starting Address
The MotionDrape LED has high output tri-color SMD LEDs perfect for DJ
backdrops with 30 patterns and support for 8 channels of DMX. The
MotionDrape LED has sound-active mode and can run a program without a
DMX512 console.
Button Menu
Power In
Fuse Holder
This product has an auto-ranging power supply that can work with an input voltage
range of 100 to 240 VAC, 50/60 Hz.
1. Disconnect this product/product from the power outlet.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder and pry
the safety cap out of its housing.
3. Remove the blown fuse and replace with a fuse of the exact same type and
rating (F 2 A, 250 V).
4. Re-insert the fuse holder and reconnect power.
The MotionDrape LED can work with a DMX controller when linked by DMX
serial connections. Instructions for connecting and configuring this product for
DMX operation are in the User Manual. If you are not familiar with DMX,
download the DMX Primer from www.chauvetlighting.com.
To ensure full access to all channels in each DMX mode, the highest
recommended DMX address is 505.
LED Display
On/Off Switch
Page 3 of 40
Front Panel
DMX In/Out
Curtain Input
Top Panel
EN