Replacing The Battery - Suunto POD Manual Del Usuario

2.3. ACTIVATING THE POD
Press and hold the Start/Stop button until the green light starts to blink.
- To deactivate, press and hold the button until the lights disappear.
After deactivation, the GPS stays 2 hours in standby mode with faster satellite finding and a
possibility to continue distance measurement of the previous workout.
2.4. CONNECTING THE POD WITH THE WRIST UNIT
Every time the POD is activated or the connection has been lost, you need to reconnect the
POD with the wrist unit.
• t6: Select SPD/DST > CONNECT in your Suunto wrist unit menu (or hold the Alt/
Back button until the CONNECT text appears).
• t3/t4: Press the Mode button to enter the Training mode or Speed and Distance
mode to connect.
'FOUND GPS POD' appears on the display when the wrist unit has found the
POD.
If 'NO DEVICES FOUND' is displayed (Suunto t6), or you receive no message
and no speed and distance information (Suunto t3 and t4), check the battery
power indicator: if the red light is on, the connection may not succeed. Replace
the batteries and try again.
If the POD does not receive a satellite signal for 15 minutes, it will automatically enter the
standby mode. The POD also goes to standby if the GPS distance accumulated is less than
35m (115ft) in the last 10 - 20 minutes. If reactivated within the standby time of 2 hours, you
can still continue the same distance measurement. Reactivating the POD after the standby
time may cause a jump in the distance in some situations.

2.5. REPLACING THE BATTERY

Low battery is indicated by a flashing red light (1/s). When the battery is empty, the POD
will automatically shut down. To replace the batteries:
1. Turn the bottom cover slightly left (counterclockwise) and detach it from the top cover.
4