Troubleshooting Guide - Garrett ACE 350 Manual Del Usuario

SYMPTOM
No power
Erratic sounds or
target ID cursor
movement
Intermittent Signals
I'm not finding
specific targets
Target ID Cursor
bounces

TROUBLESHOOTING GUIDE

1. Ensure batteries are installed in the correct position.
2. Replace all old batteries with all new batteries.
1. Ensure your searchcoil is securely connected and the coil
cable is snugly wound around the stem.
2. If using the detector indoors, be aware that excessive
amounts of electrical interference exists, plus excessive
amounts of metal can be found in floors and walls.
3. Reduce your sensitivity setting.
4. Determine if you are close to other metal detectors or other
metal structures such as electrical power lines, wire fences,
benches, etc.
Intermittent signals typically mean you've found a deeply
buried target or one that is positioned at a difficult angle for
your detector to read. Scan from different directions to help
define the signal. In the case of multiple targets switch to the
ZERO Mode or press the pinpoint button to precisely locate
all targets. In trashy areas, use the Super Sniper™ searchcoil.
(NOTE: Iron targets may cause Intermittent Signals. You can
identify iron targets in ZERO Mode).
Ensure you are using the correct mode for the type hunting
you are doing. If specifically hunting for coins, COINS mode
should be your best choice to eliminate other undesirable
targets. You may also use the ZERO mode, which detects all
metal targets to ensure desired targets are present.
If your Target ID Cursor bounces erratically, chances are
you've found a trash target. However, a Target ID Cursor may
bounce if a good target (such as a coin) is not parallel to the
searchcoil (e.g. on edge). It may also bounce if there is one
or multiple "junk" targets laying next to the good target. Scan
from different directions until your Target ID Cursor becomes
more stable.
NOTE: Large, flat pieces of iron—depending on their
orientation in the ground—can read as a good target or can
cause erratic Target ID Cursor movement.
SOLUTION
ACE 350™
35