Samsung 7 Serie Manual De Instrucciones página 118

Network Test
You can test or conirm the network connection status after setting up the network.
1 Press the MENU button to display the menu.
Press the ▲ or ▼ button to select Setup, then press the ENTER button.
P ress the ▲ or ▼ button to select Wireless Network Setup, then press

the ENTER button.
P ress the ▲ or ▼ button to select Network Test, then press the ENTER

button.
The current network settings will appear.
➣
If no Access Point Select is set up, the test cannot be completed.
➣
(See page 117)
Press the EXIT button to exit.
When unable to connect to a wireless network
1. Y our TV may fail to locate an AP that is conigured as a private SSID type.
In this case, please change the AP settings and try again.
2. If your Internet service provider has registered the MAC address of the
device used to connect to the Internet for the irst time and authenticates
the MAC address each time you connect to the Internet, your TV may not
be able to connect to the Internet as the MAC address differs from that
of the device (PC) used to connect to the Internet the first time. In this
case, ask your Internet service provider about the procedures to connect
devices other than your PC (such as your TV) to the Internet.
If you cannot connect to the Internet even if you have followed the
procedures of your Internet service provider, please contact a Samsung
Electronics Service Center.
English - 11
Network selection : Wireless
Cable Network Setup
Wireless Network Setup
V-Chip
Caption
External Settings
Entertainment : Off
Energy Saving : Off
PIP
Software Upgrade
Wireless Network Setup
Internet Protocol Setup : Auto Setup
Network Test
Access Point Select : AP1
IP Address :
0
0
Subnet Mask :
0
0
Gateway :
0 0
DNS Server :
0
0
Move Enter
Network Test
MAC Address
IP Address, Subnet, Gateway, DNS Server
Gateway Ping
Domain Ping
Network Test Completed.
►
0 0
0 0
0 0
0 0
Return
Return