Tools Required; Leg Assembly - Craftsman 152.221140 Manual Del Proprietário

TOOLS REQUIRED
The following tools are needed for assembly and align-
ment. Note: Two blade wrenches and five hex wrenches
are provided with your table saw. The remaining tools
are typical shop tools and are not included with your
table saw.
18mm wrench 8mm wrench
13mm wrench 3/16-in. hex wrench
10mm wrench #2 Phillips screwdriver
3,
Attach two tie bars (F) inside and between front and
rear legs already attached to the cabinet with (G)
eight 5/16-18 x 5/8" carriage head screws, 5/16" flat
washers, 5/16" lock washers and 5/16-18 hex nuts
and securely tighten all hardware. See figure 4-1.
DUST CHUTE ASSEMBLY
Figure 5=1
D
• The table saw is a heavy machine; two people are
required for certain assembly operations.
• DO NOT assemble the table saw until you are sure
the tool is unplugged.
• DO NOT assemble the table saw until you are sure
the power switch is in the "OFF" position.
• For your own safety, DO NOT connect the machine to
the power source until the machine is completely
assembled and you read and understand the entire
Owner's Manual.
CABINET LEG ASSEMBLY
MAKE CERTAIN the table saw is disconnected from
the power source.
1. Turn the table saw upside down onto its cast iron
table. CAUTION: The table saw is heavy; two peo-
ple are required for this operation. Be sure to lay
cardboard on the floor to protect the table surface.
Figure 4=1
A
E
F A
2,
D
Attach leg assemblies (A) to the front (B) and rear (C)
of the table saw cabinet by placing (D) eight M8 x
25ram hex head screws and eight M8 flat washers
down through the mounting holes in the leg assembly
and cabinet (E). Place an M8 flat washer, M8 lock
washer and M8 hex nut onto each of the eight screws
attaching leg assembly to cabinet. Do not completely
tighten hardware at this time. See figure 4-1.
A
B
C
1. Attach the dust chute assembly (A) to the bottom of
the table saw cabinet, making sure the opening (B)
in the dust chute is to the rear of the table saw (C).
Use (D) four M8 x 25mm hex head screws and M8
lock washers and tighten all hardware. See figure 5-1.
2.. Turn the table saw right side up. CAUTION: The
table saw is heavy; two people are required for this
operation.
Figure 5=2
_E
15
3. Attach the dust port (E) to the dust chute (F) with
four 1/4-20 x 3/8" round head tap screws.
See figure 5-2.