Craftsman 152.221140 Manual Del Proprietário página 39

Position thewoodfacingoverthecutterhead w iththe
cutterhead b elowthesurface ofthetable. Turnthesaw
onandraisethecutterhead s lowly.Thecutterhead w ill
cutitsowngroove inthewoodfacing.
• Neverusemolding cutterhead i n a bevel p osition.
Neverruntheworkpiece b etween thefenceandthe
molding cutterhead a s irregular s haped woodwill
causekickback.
CAUTION
When molding end grain, the miter gauge must be
used. The feed should be slowed up at the end of
the cut to prevent splintering
In all cuts, pay attention to the grain, making the cuts
in the same direction as the grain whenever possible.
BACKLASH ADJUSTMENTS FOR
BLADE RAISING/LOWERING AND
BLADE TiLTiNG ASSEMBLIES
If any play is detected in the blade raising/lowering or
blade tilting assemblies, the following adjustments
should be made.
Turn the power switch "OFF" and unplug the power
cord from its power source when making adjustments.
NOTE: In the illustration below, the table saw has been
turned upside down and the blade removed for clarity.
Figure 33=1
c
B A
1,
To adjust the blade raising/lowering assembly,
loosen lock-nut (A) and turn the eccentric sleeve
(B) until all play is removed in the assembly, then
tighten lock-nut. See figure 33-1
PROTECTING CAST IRON TABLE
FROM RUST
MAKE CERTAIN to turn the power "OFF" and unplug
the power cord from its power source.
The environment and frequency of human contact can
have a very detrimental impact on unpainted cast iron
surfaces. Moisture, humidity and oils (from human
hands!) can cause the unpainted cast iron surfaces to
mar or rust, so it is important to conduct routine mainte-
nance to keep your table saw looking new. Cleaning
and waxing the cast iron surfaces on a regular mainte-
nance schedule is recommended as follows:
To clean and maintain the unpainted cast iron sur-
faces:
Apply a heavy coat of WD-40 onto the unpainted cast
iron surface.
Use a fine steel wool pad to buff the unpainted cast
iron. Make sure to buff in a "front to rear" direction
only. A side-to-side buffing motion will show in the
finely ground cast iron as a flaw, defect or scratches.
Reapply WD-40 and buff the unpainted cast iron sur-
faces until the stains or rust is removed. Make sure
you use the same front-to-rear buffing direction to
avoid scratching or marring the cast iron surface.
After all stains and/or rust have been removed, clean
all oil and dirt from the table saw using a soft cloth or
rag.
Lastly, you need to apply a good automotive paste
wax to all unpainted cast iron surfaces. This will help
to protect the saw from rusting from further contact
with moisture or oily hands.
2,
To adjust the blade tilting assembly, loosen lock-nut
(C) and turn the eccentric (D) until all play is
removed in the assembly, then tighten the lock-nut.
See figure 33-1.
39