Rotex RKRTR Manual De Instalación página 39

Make sure to protect the power supply with a fuse of
3 A (X2M).
Select the power cable in accordance with relevant
local and national regulations.
A main switch or other means for disconnection,
having a contact separation in all poles, must be
incorporated in the fixed wiring in accordance with
relevant local and national legislation.
6 Put the cable bracket back into place and tighten the screws.
7 Close the receiver cover and tighten the screws.
Receiver-thermostat radio configuration
You need to configure the radio connection between the receiver
and the thermostat in order to make communication possible.
1 Put the receiver in radio configuration mode by pressing
during 4 seconds.
!
The LED lights up green and the receiver is now waiting for
a thermostat configuration address.
If needed, you can simply exit this mode by pressing
again.
2 Send the configuration address by going to code
in the installer menu on the thermostat.
Refer to "Setting up codes in the installer menu" on page 14.
The thermostat will now send radio signals. On the LCD the
j
icon flashes.
3 Verify that the radio signals are correctly received by the
receiver.
If the configuration is OK, the
radio signal received from the thermostat.
This also means that the receiver has left the radio
configuration mode.
4 On the thermostat, exit the installer menu by pressing
/
the " " code is displayed and then pressing
5 Verify if the receiver is in thermostat mode and not in manual
mode by checking if the
Refer to "LED overview" on page 12.
RKRTR + EKRTETS
Room thermostat
4PW50084-1
!
LED blinks green at each
è
LED is off.
è
è
5® 03 ®ƒ ‡≈î‹
( )
>
till
=
.
Installation manual
11