Front View; Tipping Radius; Side Tipping Radius; Door Swing Dimensions - KitchenAid Architect Serie Manual De Instalación

Front View

Width dimensions were measured from trim edge to trim
edge.
Height dimensions are shown with leveling legs extended ¹⁄₈"
(3 mm) below the rollers.
¹⁄₄
36 " (92 cm)
*When leveling legs are fully extended to 1¹⁄₄" (32 mm) below
rollers, add 1¹⁄₈" (29 mm) to the height dimensions.

Tipping Radius

Be sure there is adequate ceiling height to stand the refrigerator
upright when it is moved into place.
The dolly wheel height must be added to the tipping radius
when a dolly is used.
If needed, the tipping radius can be reduced. See "Reduce
Tipping Radius."
6
NOTE: Tip on side only.
¹⁄₈
*83 "
(211 cm)
The location must permit the door to open to a minimum of 90°.
Allow 4¹⁄₂" (11.4 cm) minimum space between the side of the
refrigerator and a corner wall.
NOTE: More clearance may be required if you are using overlay
panels or custom handles.
To adjust the door swing, see "Adjust and Remove Door."

Side Tipping Radius

¹⁄₂
90 "
(229.9 cm)
A. Tip this side only

Door Swing Dimensions

36" (91 cm) Models
90˚
110˚
130˚
A
23"
(58 cm)
51"
(130 cm)
59"
(150 cm)