Operation; General - Hatco GLOMAX GM5AH Serie Manual De Instalación Y Operación

General

GLOMAX Curved Infrared Strip Heaters are designed for ease
®
of operation. Use the following information and procedures to
operate the unit.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
BURN HAZARD: Some exterior surfaces on unit will get
hot. Use caution when touching these areas.
Standard and approved manufacturing oils may smoke up
to 30 minutes during initial startup. This is a temporary
condition. Operate unit without food product until smoke
dissipates.
Controls
GM5AH and GM5AHL Series Curved Infrared Strip Heaters
include a remote-mounted control box. The following is a list of
the controls on the control box.
Power I/O (on/off) Switch—Turns power on and off to the
heating elements and the LED light channels (if equipped).
Power Indicator Light—Illuminates when power is on, and
shuts off when power is off.
Form No. GM5AHCEM-0619
CAUTION
Startup
1. Turn on the strip heater.
• Move the Power I/O (on/off) switch to the I (on) position.
• The indicator light will illuminate (if equipped), the
heating elements will energize, and the LED light
channels will illuminate (if equipped).
2. Allow 30 minutes to reach operating temperature before
placing preheated food product underneath the strip
heater.
Power Indicator Light
Shutdown
1. Move the Power I/O (on/off) switch to the O (off) position.
• The indicator light will shut off, the LED lights will shut
off (if equipped), and the heating elements will shut
down.
9

OPERATION

Power I/O (on/off)
Switch
Control Box