Louisville AA2210 Instrucciones De Instalación página 8

B. With a straight edge, measure distances from middle
section to floor, for both A & B lengths (Figure 11).
Record the results in the space provide in table 2. Take
measurements for both the left and right rails.
Measurement to floor
Subtract for rubber shoe
C. Complete the table: Subtract 1/4" from each measurement and record in table 2 in row titled
"Cut Length"
D. Transfer these dimensions to the bottom section of the ladders right and left rails and draw
a cutting line between the two points. Trim bottom section to length using wood saw.
E. Install rubber tread to bottom ends of rail using 1" screws provided. Drill 1/16" pilot holes
into wood prior to installing screws to prevent splitting of rail (Figure 12).
Proceed to "Check the length after making your cuts" on page 9...
7
Rail cut length
LEFT RAIL
A B
(-1/4") (-1/4")
TABLE 2
FIGURE 12
FIGURE 11
RIGHT RAIL
A B
(-1/4") (-1/4")