Test Device - RIDGID AdvanTEXT RSA2AT Instrucciones De Inicio Rapido

EXAMPLE CELL PHONE SCREEN:
Unit settings
AdvanText:
Name: My Sump Pit
#1 5557654321
#2
Figure J
#3
Contractor:
Congratulations! Your installation is complete.
Contact:
STEP 8

TEST DEVICE

Press the "TEST" button to test the system. (Figure K)
EXAMPLE CELL PHONE SCREEN:
John Doe Residence
is operating correctly
Figure K
at 8:55AM on __/__/__
FLOAT TEST: Lift each float individually. Confirm that the
unit responds with an audible alarm and a corresponding
text message. When floats are returned to home position,
an "OK" text message should be received.
POWER TEST: Unplug A/C power (for 10 seconds).
Confirm that alert text message is received. Restore power
and an "OK" text message should be received.
Unplugging power during this step will also
cause the primary pump to be off if utilizing
the piggy back cord plug. (integrated alarm system only)
Text messages may take up to (1) minute to
receive and is based upon signal strength and
cellular network congestion. If text message is not received, refer to
troubleshooting section.
INSTALLING WITH A SOLID BASIN LID
If you are installing a sewage pump or a sump pump into
a basin with a solid lid, you will need to remove the power
cord, (Figure L) and feed the dual float sensor cord and
the power cord through the sump lid, then reattach. When
reattaching the power cord to the pump, make sure the
plug is oriented in the correct position as shown.
Follow and comply with all local and state requirements
for Radon regulations and installation requirements in your
area to complete installation.
Use a maximum of 10-15 in/lbs of torque when
fastening power cord to
Model RSA2AT – Operating Instructions and Parts Manual
HOW TO CHANGE A PHONE NUMBER
If you have entered an incorrect number to one of the
three emergency contact numbers that will receive a text
alert, or if you want to update a phone number, you must
first clear the old number by texting the word "none"
after the phone setting you want to change, e.g., type
Phone1{space]none
Refer to Step 7 to enter the new phone number.
"NAME" COMMAND
If you are a property manager, a plumber or someone with
multiple devices, you may want to give each device a
unique name. This way the location where the text alert is
originating from is clear. To change the device name from
the default name, type the following command:
Name{space}John Doe Residence
If successful the device will chirp and you will receive a
text message with the current settings.
"STATUS" UPDATE
If you wish to receive an update from your device at any
time, you can simply text "status" to the device and it will
respond with a text message.
"SETTINGS" UPDATE
You can also text "settings" to the device and it will
respond with a text message with the current settings
stored in the device that you have setup. Pushing the
"TEST" button will send a text message to all numbers
configured in the device.
something other than your standard text alert ringtone. This way,
you will be able to differentiate between a regular text message and
the AdvanTEXT device warning alert messages.
NOTE ORIENTATION
AND NOTCH IN PLUG
pump.
Ridge Tool Company
OPTIONAL USER COMMANDS
NAMING MULTIPLE DEVICES
DEVICE INTERACTION
It is our recommendation to change the
text ringtone from the AdvanTEXT device to
MAXIMUM 10-15 IN/LBS
OF TORQUE
Figure L
5