Changing The Fuse; Parts Package; Operating- And Adjusting Elements, Connecting - Fixpoint EP 5 digital Manual De Instrucciones

Manual
and liability".
• Do not use damaged parts.
• The soldering station may only be installed and used in dry interior rooms.
• Do not let the soldering station out of view.
• Do not plug things like metal parts and unfitting cables into ventilation slots or ports.
There is a risk of electric shock and short circuit!
• Keep enough space around all devices for a good ventlation and free motion and to
avoid damages.
• Take care of protecting the conducting blank metal of cables and contacts from contact
by suitable means like covering, insulation with non combustible material.
• Please observe the recommendations of the manufacturer regarding the application of
suitable soldering material such as solder paste, solder tincture, etc.
Changing
Replace the fuse with a fuse of the same type (T 1A / 250V, 5 x 20 mm). Never bypass a
the Fuse: fuse or replace it by a stronger one! Replace the fuse only after switching off and
disconnecting the device from mains. Let the device cool down before. Open the safety
switch at the back of the device with a suitable screwdriver and remove the burnt out
fuse from the holder cap. Relock the safety switch entirely after replacing the fuse.
• During transport, observe the details listed in the Chapter "Specifications", and imple-
ment measures suitable for transport, e.g. use the original package.
• For questions, defects, mechanical damages, malfunctions, and other functional
problems which cannot be resolved by this guide, please contact your dealer for repair or
replacement, as described in the Chapter "Warranty and Liability".
• Mind chapter "Specifications".
• Please also observe the terms of use described in the Chapter "Intended Use".

4 Parts Package:

• 1 pc. soldering station EP 5
• 1 pc. soldering iron 48 Watts with solder tip
• 1 pc. user's manual

5 Operating- and Adjusting Elements, Connecting:

12
1. Digital LC-Display- for set and actual
soldering temperature
2. Mains switch for switching the device
on and off.
3. UP/DOWN keys to set the desired
soldering temperature
4. 4-pole diode plug for connecting the
soldering station to the soldering iron
5. Stand for the soldering iron with
contact protection and pull-out
sponge.tray.