Troubleshooting; Warranty And Liability - Fixpoint EP 5 digital Manual De Instrucciones

Manual

8 Troubleshooting:

Problem
The soldering station does not
heat up.
ERROR and humming signals
No good soldering joint is
practicable.
The temperature is not
adjustable.

9 Warranty and Liability:

• The producer grants a 2 years warranty to a new device.
• As the manufacturer has no influence on installation, warranty of the product only
applies to the product.
• If any fault or damage is detected on your device, please contact your dealer and provide
your sales slip or invoice as evidence of the purchase, if necessary. Your dealer will
repair the fault either on site, or send the device to the manufacturer. You make the work
of our technicians considerably easier, describing possible faults in detail – only
then you can be assured that faults, occurring only rarely, will be found and repaired with
certainty! If your dealer cannot be contacted, you can also contact us directly.
• The manufacturer is not liable for damages to persons or property caused by improper
installation or operation not described in this guide. This includes, among others, any
alteration and modification of the product and its accessories.
• Any use other than described in this user's guide is not permitted, and causes loss of
warranty, loss of guarantee, and non-liability.
• We reserve our right for misprints and changes of the device, packing, or user manual.
16
Help
Check the mains connection.
Check the fuse of the device after separating and
cooling-down of the device (chapter 3).
Disconnect the device from mains immediately and
consult your dealer (also look at chapter 6.3).
Read chapter 6.4.
Read chapter 6.3 or consult your dealer.