Junghans j800.1 Manual De Instrucciones página 5

2. automatic calibre j800.1
3
25
2
25
a b c
4
5
2.1. winding up the watch
with the winder in position a, you can wind up the automatic move-
ment manually. at least 2 to 3 rotations of the winder are needed to
start the movement. it is better to wind it up completely. it is fully wound
up after c. 30 rotations of the winder, as then the maximum accuracy
and its power reserve (even after the watch is put down) will last for
the maximum period. after you have set your watch, you should wear
it, so that the automatic winding system (via rotor movement) keeps it
constantly operational.
24
1 = crown
2 = hour hand
3 = minute hand
1
4 = second hand
5 = date display
(varies by model)
2.2. setting the time
pull the winder into position c. that stops the watch movement. to set
your watch accurately to the second, it is best to stop the movement as
the second hand is passing the figure 60. you can now position the
minute hand precisely in line with the relevant minute marker and set
the desired time. press the winder back into position a to start the
second hand.
2.3. setting the date (varies by model)
pull the winder into position b. you can now set the date by turning it
to the right. do not make any changes to the date between 8pm and
2am, as the date is automatically advanced by the movement during
this period and you could damage the date advance mechanism.
if the month has less than 31 days, set the date manually to the first
day of the following month.
25