Publicidad
Idiomas disponibles
Idiomas disponibles
attach to
2
S T E P
p h o n e a n d h e a d s e t
1. Unplug your telephone's handset cord from
the telephone base.
2. Plug your telephone's handset cord into the
Switcher amplifier handset jack ( ).
3. Connect your telephone base to the Switcher
amplifier telephone jack ( ) using the short
curly cord. On your telephone base, plug the
short curly cord into the outlet normally
used for your handset.
4. Plug the headset cord into the Quick
Disconnect
cord coming from the front of the amplifier.
The QD will allow you to disconnect the
headset from the amplifier when you are
not using the phone, or need to move
away from the amplifier, while leaving
your headset in place.
2
I N S T A L L A T I O N S T E P S
™
(QD) module on the long curly
e n g l i s h
I N S T A L L A T I O N S T E P S
set default
3
S T E P
s e t t i n g s
These are the default settings for
headset use.
1. Headset /Handset Selector is switched
to Headset ( ).
2. Telephone/Computer Audio Switch is
released (no red indicator showing).
3. Microphone Switch is released (no
red indicator showing).
4. Incoming Volume Thumbwheel is set to 4.
5. The Outgoing Volume Control has been
pre-set. You can adjust it when you
place your first call (see page 7).
e n g l i s h
2
3
4
5
6
2
3
4
5
6
2
3
4
5
6
3
Publicidad
