• Place the Rip Guide on the top of the cutting table and fold
down levers on each side until they snap into place. The
guide is marked in both inches and centimeters for accurate
cutting. Rip guide can be used on either side of the
cutting blade. (See Diagram 2)
• For straight cutting, after the rip guide is positioned for
the desired cut, place the material flush against the rip
guide then push the material towards the blade. (See
Diagram 3)
• For miter cutting, raise the tip-up cutting table to the desired
angle and position the miter support in one of the slots
behind the table. You can choose 15°, 30°, 45°. Place the
material onto the cutting table and you are ready to cut.
(See Diagram 4)
• For 45° angle cutting, put the tile and 45° angle cutting
guide together. Then push towards the blade to cut the
tile. (See Diagram 5)
Note: Be sure to keep the reservoir filled with water to the
recommended level.
For longer tool life and best performance:
• Always clean the tile saw after each use.
• Wipe off all exterior surfaces and keep the cutting table clean and free of all debris.
• Always let the blade cut at its own speed. Do not force the material being cut.
• Always check the blade for cracks or signs of damage.
• Always clean the reservoir thoroughly after use.
• Always store the electrical cord underneath the saw after use.
• Always keep water level at the recommended level. Do not overfill or allow the saw to run dry.
Add water if necessary.
• Never attempt to service the internal parts of the motor by yourself as this will void our guarantee.
DIAGRAM 4
- 7 -
Pivot
Tab
DIAGRAM 2
DIAGRAM 3
DIAGRAM 5