Installation And Mounting - Code 3 Citadel MATRIX Serie Manual De Uso

Unpacking and Pre-Installation:
Carefully remove the product and place it on a flat surface. Examine the unit for transit damage and locate all parts. If damage is found or
parts are missing, contact the transit company or Code 3. Do not use damaged or broken parts.
Ensure the product voltage is compatible with the planned installation.

Installation and Mounting:

CAUTION!
When drilling into any vehicle surface, make sure that the
area is free from any electrical wires, fuel lines, vehicle
upholstery, etc. that could be damaged.
Refer to vehicle specific installation for mounting instructions.
Control box recommended mounting hardware: #8-#10.
Max mounting torque 35in-lbs using #10-32 with flange nut or
washer on flat surface. Different mounting hardware or surface will
affect max torque limits
Figure 1
Page 2 of 8