Troubleshooting - Black and Decker LCS1020 Manual De Instrucciones

trouBlesHooting

If your Chain Saw does not operate correctly check the following:
problem
• Tool will not start.
• Unit will not charge.
• Bar / chain
overheated.
• Chain is loose.
• Poor cut quality.
• Unit runs but does
not cut.
• Unit stops while
cutting.
• Unit does not oil.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK+DECKER help line at 1-800-544-
6986.
possible cause
• Battery not installed
properly.
• Battery not charged.
• Lock-out button not
actuated.
• Battery not inserted into
charger.
• Chain too tight.
• Lubrication needed.
• Chain tension set
incorrectly.
• Chain tension set
incorrectly.
• Chain needs
replacement.
• Chain installed
backwards.
• Lithium battery depleted.
• Voltage limit protection
exceeded.
• Battery too hot.
• Oil reservoir emptied.
• Oiling hole on guide bar
clogged.
possible solution
• Check battery installation.
• Check battery charging
requirements.
• Push lock off button/actuate trigger.
• Insert battery into charger until green
LED appears. Charge up to 5 hours
if battery totally drained.
• Refer to "adjusting chain
tension" section.
• Refer to "chain oiling" section.
• Refer to "adjusting chain
tension" section.
• Refer to "adjusting chain
tension" section.
Note: Excessive tension leads to
excessive wear and reduction in
life of bar & chain. Lubricate before
each cut. Refer to "replacing the
chain" section.
• Refer to sections for installing and
removing chain.
• Charge battery.
• Unit is being forced. Restart and
apply less pressure.
• Allow battery to cool for 30 minutes
before proceeding.
• Refill reservoir.
• Clean guide bar, sprocket and
sprocket cover. Refer to "care and
maintenance" section.
16