Important; Adjusting The Controls - Roscoe Medical TENS 3000 Manual De Instrucciones

Important

1. Do not apply to broken skin.
2. The electrodes should be discarded when they are no longer in use.
3. The electrodes are intended for single patient use only.
4. If irritation occurs, discontinue use and consult your clinician.
5. Read the instruction for use of self-adhesive electrodes before application.
Chapter 17: ADJUSTING THE CONTROLS
1. Slide Cover:
A slide-on panel cover covers the controls
for Pulse Width, Pulse Rate, Mode Selector,
and Modulation Selector. Your medical
professional may wish to set these controls
for you and request that you leave the cover
in place.
2. Display LED:
Each of the LEDs illuminates whenever the
electronics of the device create a current
impulse. Due to the capacity of the human eye,
the illumination of the lamp can only be
recognized up to a frequency of approximately
30Hz. At higher frequencies, the lamp will appear
to be constantly illuminated.
3. On/Off Switch and Intensity Control:
If both controls are in the off-position (white markings on the housing), the
device is switched off.
14
By turning the controls clockwise, the appropriate channel is switched on and the
impulses display LED will illuminate and begin to pulse according to the frequency set.
The current strength of the impulses transmitted to the electrodes increase further
when the control is turned clockwise.
To reduce the current strength or switch the device off, turn the controls counter
clockwise to the required setting or off-position.
LED
COVER
4. Lead Connector:
Connection of the electrodes is made with two-lead connector. The device must
be switched off before connecting the cables. both intensity controls must be at
the Off position. Electrodes must be pressed firmly on the skin.
Turn Power On
Turn
Adjust Intensity Power Off
LEAD CONNECTOR
15
PLUG