Operation - Hisense RW54N1SSD Manual De Operación

11

Operation

Before plugging in you cooler for the first time remove all packaging, clean the cooler with a
soft rag and a mixture of lukewarm water and baking soda(2 tablespoons baking soda in 1
quart of water works well). Wipe dry with soft cloth.
Note: Let stand upright for at least 4 hours before plugging in, to avoid potential damage to
the compressor.
Temperature Control
RW46N1DSD
Note:The set temperature range for both upper and lower compartments is 39 deg F to 64
F (4 deg C to 18 deg C).
①. " " Turn Wine Cellar ON/OFF
To turn this unit ON and OFF, press and hold this button for approximately 3 seconds.
" Energy Saver
②."
Energy Saver button:Pressing this button for 3 seconds will turn the energy saver mode
either ON or OFF. When the energy saver mode is ON, the LED light and display will be
turned
off, the °F / °C light will be on.
" Set temperature lower
③."
Each pression will lower temperature of the upper chamer 1°F(or 1°C).
" Set temperature higher
④."
Each pression once will increase temperature of the upper chamer 1°F(or 1°C).
⑤. LED Temperature Display
Display temperature for the upper zone.
" Compressor Indicator Light
⑥."
Indicates that compressor is operating.
⑦." °F / °C " Indicator Light
Will change as the " °F/ °C " button is pressed.
⑧.LED Temperature Display
Display temperature for the lower zone.
" Set temperature higher
⑨."
Each pression will increase temperature of the lower chamer 1°F(or 1°C).
" Set temperature lower
⑩."
Each pression will lower temperature of the lower chamer 1°F(or 1°C).
⑪." °F/ °C " Switch
Pressing this button switches the indicator light between °C and °F.
Hisense Wine Cooler