Using Your Appliance - Hisense RW54N1SSD Manual De Operación

13
Setting the temperature
Use the / buttons to set the desired temperature of the appliance. Each time the /
buttons are pressed, the temperature will increase / decrease by 1°F(or 1°C).
The temperature can be set between 39°F to 64°F(4 deg C to18 deg C).
Setting Temperature Memory Function
If the power failure happens , the set temperature will be saved by the unit. Once the power is
back on, the unit will resume cooling at the same set temperature.
"Close Door"Reminder Function
If the door is not fully closed, there will be warning alarm after 2 minutes. Press the light
button" ", the warning alarm will be suspended for 5 minutes.
Then the warning alarm continues again and won't stop until the door is closed.
Defrosting
Note that under most temperature settings, the unit will automatically defrost under most
ambient conditions. However, on colder settings, some frost may build up. Additionally, the
more humid the ambient conditions, the more frost may build up. Keep the door closed as
much as possible and avoid opening the door unless necessary to minimize frost build-up.
It is not advisable to scrape off ice and frost with sharp tools or wooden bars, so as not to
damage the appliance.

Using your appliance

Racks
RW46N1DSD
To prevent damaging the door gasket, make sure to open the door enough to clear the racks when
pulling them out. For easy access to the bottles, fully extend the racks all the way out.
To remove the shelves from the rail, pull each shelf approximately 1/3 out. Use a long flat screwdriver
to press down the left plastic notch as show in Figure A and at the same time lift the right plastic notch
as show in Figure B. The proceed to remove the shelf slowly.
Hisense Wine Cooler