Fisher&Paykel DE62T27C Instrucciones De Instalación página 28

Installation instructions
'I
2
3
4
5
3-wire connections plus separate grounding connector
For use where [ocam codes do not permit grounding through the Neutral wire.
Use approved 3-wire Power Supply Cord or a 3-wire CaMe for Direct Wiring as described on page 23.
A separate I OAWG copper grounding wire is required.
Remove the terminal block cover plate.
insert the power supply cable with a UL listed strain relief through the hole provided in the cabinet
near the terminal block, Do not tighten strain relief screw until wiring connections are complete.
Note: a strain relief must be used.
strain relief
clamp sections
(( strain re[i_
screws
Fig.27 Inserting the power cord
Remove center terminal block screw.
Remove appliance ground [ink by removing the ground connector screw (Green screw).
Connect a separate copper ground wire (green with yellow stripe) using the ground connector
screw (Green screw). Make sure a ring terminal is used when connecting the ground wire and that
the wire is firmly secured to an adequate grounding path.
Note: If the appliance is
moved back to a 3-wire
installation the ground
link must be refitted,
7
5
Remove link
Fig,28 Connecting the wires
6 Connect the neutral wire (center) of the power supply cord to the center terminal screw of the
terminal block. Tighten screw.
7 Connect the other wires to the upper and lower terminal block screws marked with the letter L
Tighten screws.
8 Refit terminal block cover by inserting the two tabs first on the rear panel of the dryer and secure
cover with securing screw.
9 Tighten strain relief screws.
S
i
9
It is recommended that a qualified electrician 1 Fig,29 Refitting terminal
determine that the ground path is adequate I blockand tightening screws