Philips SCE4430 Manual De Instrucciones página 4

SCE4430 17-09-2007
4 Functional overview (fig. A)
Power indicator
1
Indicates the battery status.
Battery check button
2
Activates the power indicator.
RESET
3
Resets the power pack to the factory default settings.
INPUT 5V DC (mini USB)
4
Connects to the mains supply.
USB port
5
Connects to 5V DC devices (mobile telephones,
MP3 players, etc.).
5 Operation
Charging the power pack (fig. B)
Press the battery check button (2).
1
> One, two or three LEDs light up in the power
indicator (1), indicating the current battery status.
If all four LEDs light up, the battery is fully charged.
Connect the retractable cable to the USB charger.
2
Connect the mini USB connector tip to the other end
3
of the retractable cable.
Connect the mini USB connector tip to the
4
rechargeable power pack.
Connect the power plug of the USB charger to a wall
5
outlet.
> The power indicator LEDs (1) will flash one after
another, indicating that the battery is being charged.
> When all LEDs light continuously the battery is fully
charged.
Disconnect the battery pack from the AC power
6
adapter and disconnect the AC power adapter from
the wall outlet.
13:29 Pagina 4
Note:
You can also charge the power pack via the USB
output of your PC/notebook. Connect one side of the
USB cable to the power pack (5V DC mini USB) and
connect the other side of the retractable USB cable to
the USB outlet of your PC/notebook.
Charging devices - preparation
1 Check the maximum input voltage (V DC) of the
device you wish to connect. For this see the user
manual that came with the device.
Make sure the device does not consume more current
2
(mA) than 350 mA.
3 Check what connector tip is required for your device.
See the compatibility sheet for the proper tip for your
device.
Charging 5V devices (fig. C)
Insert the plug of the USB cable into the USB port (5).
1
Connect the connector tip to the USB cable.
2
Insert the connector tip into the power supply jack of
3
the device.
> The device will now derive it's power from the
power pack.
> If the device has a charging indicator, it will indicate
that the device is being charged.
Note:
If you are unable to solve a problem by following the
above hints, try resetting the power pack by pressing
RESET.The RESET button is recessed to prevent
accidental reset of the power pack. Use a paperclip to
gently press the RESET button (see fig. D).
Tip:
For several portable devices (5V), a USB connection
cable is supplied with the original device (e.g. most
MP3 players). In this case, you can also use this cable
to charge your device.
4