VWR 89369-158 Manual De Instrucciones página 6

 
5. Press the or button to increment the display to the desired high alarm value.
6. Press the SET button. The low alarm limit for the ambient relative humidity will appear. The alarm value and "Lo"
will flash on the display.
 
7. Press the or button to increment the display to the desired low alarm value.
8. Press the SET button. The high alarm limit for the ambient relative humidity will appear. The alarm value and "Hi"
will flash on the display.
 
9. Press the or button to increment the display to the desired high alarm value.
10. Press the SET button. The low alarm limit for the dew point temperature will appear. The alarm value and "Lo"
will flash on the display.
 
11. Press the or button to increment the display to the desired low alarm value.
12. Press the SET button. The high alarm limit for the dew point temperature will appear. The alarm value and "Hi"
will be flashing on the display.
 
13. Press the or button to increment the display to the desired high alarm value.
14. Press the SET button. The data logging rate will flash on the display (see the "Adjusting Data Logger Recording
Rate" section).
15. Press the SET button to return to the current temperature/humidity display.
VIEWING HIGH/LOW ALARM LIMITS
Once alarm limits have been set, follow the steps in the "Setting High/Low Alarm Limits" section to view the values that
have been set. If no changes are desired, do not press the
the next value.
DISABLE/ENABLE HIGH/LOW ALARM LIMITS
Once alarm limits have been set, follow the steps in the "Setting High/Low Alarm Limits" section to view the values that
have been set. Press the SET button to cycle through the values that have been set.
An alarm limit may be disabled while being displayed by pressing the MIN/MAX button, "- -.-" will appear on the display
indicating the alarm for the value is disabled. When an alarm value is disabled, the alarm value previously set will be
cleared.
To enable an alarm that has been disabled, while viewing the disabled alarm ("- -.-"), press the
increment the value to the desired alarm value. With an alarm value selected ("- -.-" no longer appearing), the alarm
will be enabled.
Each High/Low alarm limit may be independently enabled/disabled allowing selecting of high alarm only, low alarm only,
or both high and low alarm monitoring.
 
or buttons, simply press the SET button to move to
VWR Collection Manual ver 3, rel 5 30.10.2013
 
or button to