Honeywell RTH6450 Guía De Instalación Rápida página 28

Advanced Installation Guide
Heating or
cooling system
does not
respond
"Cool On" or
"Heat On" is
flashing
Heat pump
issues cool air
in heat mode, or
warm air in cool
mode
Heating system
is running in
cool mode
69-2696ES—02
69-2696ES_A.indd 26
Troubleshooting
• Press SYSTEM button to set system
to Heat. Make sure the temperature
is set higher than the Inside
temperature.
• Press SYSTEM button to set system
to Cool. Make sure the temperature
is set lower than the Inside
temperature.
• Check circuit breaker and reset if
necessary.
• Make sure power switch at heating &
cooling system is on.
• Make sure furnace door is closed
securely.
• Wait 5 minutes for the system to
respond.
• Compressor protection feature is
engaged. Wait 5 minutes for the
system to restart safely, without
damage to the compressor.
• Check Function 2: Heat Pump
Changeover Valve to make sure it is
properly configured for your system
(see page 15).
• Check Function 1: System Type to
make sure it is set to match your
heating and cooling equipment (see
page 14).
26
1/5/2012 10:17:08 AM