Important; En Standard Wall Mounting Instructions - EVOKO LISO Instrucciones Para El Montaje

EN

IMPORTANT!

Read the safety instructions carefully before using the mounting instructions.
1. Unmount the back plate of the device, by carefully turning it counter clock wise. Use a spirit level to adjust it horizontally.
Height from floor to center of device approximately 1500 mm / 5 ft.
2. Use the holes in the back plate to mark out hole positions on the wall.
3. Decide on the direction you want to exit the cables and make sure the hole for the cable exit is facing this direction.
Note! If you plan to route cables into the wall using the big open area in the middle of the back plate we recommend facing
the cable hole either up or down, not sideways.
4. Make sure that the markings are exactly leveled and drill the holes for the mounting bracket. Mount the back plate to the
wall with the screws and route the cables through the appropriate cable channels on the device.
Note! Use 2 – 4 screws depending on the structural capacity of the wall. Always drill holes and use suitable plugs for wall
types such as concrete, plaster etc. Choose a screw type that is suitable for the type of plug and wall concerned. Use screws
with a diameter of 4 – 5 mm / gauge # 7 - 10 and minimum length of 35 mm / 1- 3 /8". If uncertain always contact a specialist
or dealer for assistance with wall mounting.
Note! Do not remove the protective film on the back of the mounting bracket. The "sticky surface" should only be used for
glass wall mounting.
5. Mount the device on the bracket by fitting the talons on the back plate with the holes in the device and gently turn it
clockwise to snap it in place. Secure it with the safety screw.
Standard wall mounting instructions
For the latest instructions go to: www.evoko.se/downloads
6