Section 11 - Wire Routing Procedure - Holland RK-10855-L Instrucciones De Instalación

Installation Instructions
11. Wire Routing Procedure
1. Mount the display box in the cab so that it is easily
visible and accessible to the driver. Clean the dash and
display box mounting surfaces with isopropyl alcohol,
and allow to air dry. Use the provided, re-closable
adhesive fastener to mount the display box on the dash.
2. Route the cable on the Electronic Lock Indicator (ELI)
display box to approximately where the 25' extension
cable will enter the cab.
3. Install corrugated loom around extension cable
(Figure 28).
4. Cut one (1) slit into the grommet (Figure 29).
5. Wrap the grommet around the 25' extension cable in the
approximate location where it will enter the cab.
sure that there are no obstructions near the drilling area.
7. Run the end of the 25' extension cable with the power
lines through the utility hole and into the cab.
8. Install the 1-amp fuse, which is included with the
extension cable (Figure 30).
power wire and the tractor's positive (+) power wire.
It is recommended that a switched terminal in the
main fuse box be used so that power is supplied
when the ignition is turned on.
b. Insert the wires into each end of the fuse holder.
c. Crimp the terminal through the fuse holder body.
Failure to connect a voltage source that
matches the specification on the box
will result in a damaged and inoperable
display box.
9. Connect the 2-wire power cable from the extension cable to
a 12- or 24-volt power supply. (The back of each display
box is marked with 12- or 24-VDC.) Be sure to connect the
RED wire with the fuse — as outlined in Step 8 — to the
positive (+) terminal, and the BLACK wire to the (-) terminal.
14
Figure 28
Figure 29
Figure 30
XL-FW10064BM-en-US Rev A · 2011-12-02 · Amendments and errors reserved. © SAF-HOLLAND, Inc.