Remote Control - GHP Group 18-600-310 Instrucciones De Instalación Y Funcionamiento Para El Propietario

Operating Instructions - Fireplace Control Functions

Remote Control

The infrared remote control relies on a line of sight and must be pointed at the flame/screen of the
fireplace to work. The remote control unit has the controls required to turn ON/OFF both the main
power and the heater. If you prefer to use the touchpad control on the fireplace unit itself, open the
hinged door on the upper right hand side of the fireplace to access the touchpad buttons. The layout
of the buttons on the touchpad and remote control unit can be seen in Figures 3 & 4, respectively.
1. Plug your fireplace into a 15 amp
120 volt power outlet.
2. Turn the power on (see illustration for Main Power
Button location). Flame will show on the back
screen of the fireplace.
3. Remove plastic tab from inside battery compartment
to activate remote control. (see Figure 5)
4. Point the remote control directly at the fireplace
flame/screen and use the buttons to operate
the fireplace.
Figure 4
Remote Control
1.
Main Power Button:
This button supplies power to all the functions of the fireplace. The Main power button must be
in the ON position, either from the remote or on the touch pad for the functions to work.
NOTE: Be sure the unit is unplugged before installing, moving or performing maintenance.
2.
Heater Control Button:
This button controls the heater ON/OFF and 5 temperature modes from High to Low. When the
fireplace is first turned on, the heater will come on at the highest room temperature setting.
Each time the Temperature button is pressed, the temperature set point decreases, allowing you
to adjust the ambient temperature.
3.
Flame Control Button:
This button controls the brightness of the flame effect with settings at High, Medium and Low.
When the fireplace is first turned on, the flame will come on at the highest setting. Each time the
Flame button is pressed, the flame brightness decreases. The only way to turn off the flame effect
completely is to turn off the Main Power button.
Figure 5 / Battery
The plastic tab inside the battery
be removed before remote control
1
2
3
Electric Fireplace Insert 18/
compartment MUST
will operate. (pull tab)
23
10